![]() Apply blue Loctite to the provided mounting screwsĢ Button Head Cap Screws - Provided for Vortex Viper and Venom SightsĢ Flat Head Cap Screws - Provided for Burris FastFire and Docter SightsĢ Flat Head Cap Screws - Provided to mount the Plate to the Dovetail (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Place the red dot sight on the EGW Sight Mount Install the EGW Sight Mount in the dovetail You can take our mount off and replace your rear sight at any time. Simply remove the rear sight on your gun and replace it with our mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. The dovetail has a progressive taper to allow for easier install. Our Beretta 92 red dot sights mounts are meant to be installed from the left to the right (with the muzzle facing forward). We would recommend either sending the red dot back for an exchange to whichever seller you purchased it from, or open up the holes in the bottom of the red dot to accommodate the pins.ĭo you need to install a red dot mount on your Beretta 92? Our red dot mount allows you to easily install a red dot on your Beretta. These dots may not fit properly on the posts on the plate. Please note: We have found that some red dots commonly found on Amazon such as the UTG and ADE may not hold the same tolerances as the red dots that this mount was initially created to work with. *All ADE mounts require 6-32 x 3/8" screws. The mounting screws require a 5/64" wrench and the set screws (when applicable) require a 1/16" wrench. (2) 6-32 x 5/16" Flat Head Screws - To Secure Plate to Insert - Requires 5/64 Wrench or Driver (2) 6-32 x 3/8" Flat Head Screws - Requires 5/64 Wrench or Driver (2) 6-32 x 5/16" Button Head Screws - Requires 5/64 Wrench or Driver
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |